Dumb Bunny Cake Recipes

Steps:

• Spread a thin layer of frosting (about 2/3 cup) on the flat side of one cake layer and top with the flat side of the second cake layer. Measure 5 inches across the top of the cake and cut down through the layers, creating 2 layered pieces that are slightly different sizes.
• Place the larger piece of cake cut-side down on a large platter or cake board. If using a rectangular cake board, place the larger piece so that the long edges are parallel with the long edges of the board. This is the body of the bunny. Cut the smaller piece of cake in half crosswise, so you have 2 layered wedges. Place one wedge in front of the body, with one flat side on the board and the other flat side against the body. The curved side will be on top. Take a serrated knife and round off the sharp edges on top of the head. Cut the tip off (the nose) at a 45-degree angle. Reserve all scraps in a bowl.
• Separate the layers of the remaining wedge of cake. These will be the back legs. Round the sharp edges of the cake wedges with your knife and add to the scrap bowl. Place one piece on each side of the bunny, with one flat side down and the other flat side facing forward (the round side towards the back of the bunny), about 1 inch from the end of the bunny's body.
• Mix the cake scraps in the bowl with a fork until mashed and then pack into a ball with your hands. Place the ball behind the bunny's body and adhere with a dab of frosting. This is the bunny's tail.
• Frost the entire bunny, tail and all, using 2 to 3 cups of the frosting, keeping some definition with the bunny parts and frosting more generously around any sharp edges to give a rounded look to the bunny parts. Sprinkle the bunny with the coconut to fully cover. Gently pat to adhere.
• Insert the biscotti between the head and body, pressing into the cake to secure them. These are the ears. Place the base of the ears close together at the center of the head and angle them out. Frost the front of each biscotti with some frosting. Then, using the pink decorating icing, frost a smaller strip in the center of each biscotti, going down to where the ears meet the head but not going all the way to the top.
• To make the face, press a black jelly bean into each side of the head for the eyes. Cut one of the marshmallows into 3 circles, discard the middle piece and press the 2 end circles, cut-sides in, into the front of the face for the bunny cheeks. Push the white jelly bean halves into the face below the cheeks, round-sides out, for the teeth. Place the pink jelly bean above for the nose.
• Unroll the licorice wheel and cut 2 pieces, each about 1 1/2 inches long. For each piece, peel the strips apart halfway down and then cut each separated strip in half lengthwise so you end up with a piece looking a bit like a broom. Repeat with the second piece of licorice. Tuck each piece, with a dab of frosting, behind a marshmallow cheek, with the cut ends facing out for the whiskers.
• Cut the second marshmallow in half lengthwise. Make 3 slits in each half, going about halfway through (these are the toes), and place in front of the legs for the bunny's feet. Adhere the bottom of the feet with frosting if necessary.
• Combine the butter, confectioners' sugar and salt in the bowl of a stand mixer fitted with a paddle attachment. Mix on low speed until mostly incorporated. Add the vanilla, increase the speed to medium-high and mix until smooth. Adjust the consistency with milk as desired.
• Preheat the oven to 350 degrees F. Spray two 10-inch round cake pans with baking spray.
• Beat the butter and granulated sugar in a stand mixer fitted with the paddle attachment on medium-high speed until fluffy, about 4 minutes.
• While you are beating your butter, whisk the flour, baking powder and salt together in a separate bowl.
• Beat the eggs into the butter mixture, one at a time, scraping down the bowl as needed. Beat in the vanilla.
• Reduce the mixer speed to medium low; beat in half the flour mixture, then all of the milk, then the remaining flour mixture until just combined.
• Divide the batter evenly between the prepared cake pans. Bake until a toothpick inserted in the center of a cake comes out clean, about 35 minutes, rotating the pans halfway through.
• Transfer the pans to a rack and let cool 10 minutes, then invert the cake layers onto a wire rack and cool completely before decorating.

Steps:

• Place a rack into the lower third of oven.
• Preheat oven to 325 degrees F (165 degrees C).
• Grease and flour a cake mold pan (such as a bunny cake or train cake mold) using vegetable shortening.
• Sift flour, baking powder, and salt in a bowl.
• Mix 1 1/3 cup milk, lemon extract, 1 1/4 teaspoons vanilla extract, and orange extract in a separate bowl.
• Beat unsalted butter in a large mixing bowl with an electric mixer on medium speed until butter is creamy and smooth, 1 to 2 minutes. Beat in white sugar and continue beating until the mixture is light and fluffy, about 5 more minutes. Scrape the sides of the bowl occasionally.
• Beat in eggs, one at a time, beating each egg in thoroughly before adding the next.
• Reduce mixer speed to low and beat in flour mixture in several additions, alternating with milk mixture; begin and end with flour mixture. Do not overbeat. Scrape bowl occasionally.
• Pour batter evenly into prepared cake pan.
• Bake in the preheated oven until lightly browned and a toothpick inserted into the middle of the cake comes out clean, 30 to 45 minutes.
• Place cake in pan on a wire rack and allow to cool for 15 minutes before inverting pan to remove cake. Allow cake to completely cool on wire rack, 3 to 4 hours.
• Beat vegetable shortening, 1/2 cup butter, confectioners' sugar, 2 tablespoons milk, and 1 teaspoon clear vanilla extract in a bowl until frosting is smooth and creamy.
• Pack the frosting into a heavy resealable plastic bag; force the frosting into one corner of the bag. Clip a small corner off the plastic bag, seal the bag, and pipe the frosting onto the cooled cake in desired pattern.

Steps:

• Heat oven and prepare two 9 inch round baking pans as directed on cake box. Prepare cake batter with as directed on package adding in 1/2 cup of coconut. Divide batter evenly between the prepared pans. Bake and cool cake as directed on package.
• When cooled, place one whole 9 inch cake layer on serving tray, forming the bunny's head. Cut 2 convex shaped ears from each side of the second layer, place on each side of head to form ears. Use concave shaped piece for the bowtie, place about 1/2 inch below head.
• Frost entire bunny covering top and sides of bunny. Pat remaining 3 1/4 cup coconut evenly over top and sides. Decorate the bunny face and bowtie with jellybeans and use the licorice to make whiskers.

Steps:

• Heat oven to 350°F (325°F for dark or nonstick pans). Make, bake and cool cake as directed on box for two 8-inch or 9-inch round pans.
• Reserve 1 layer for another use or to make a second bunny. Cut 1 layer in half as shown in diagram. Put halves together with frosting to make body. Place cake upright on cut edge on tray.
• Cut out a notch about one-third of the way up one end of body to form head (small end) as shown in diagram. Attach half of cutout piece from tail with toothpicks. Frost with remaining frosting, rounding body on sides. Sprinkle with 1 cup coconut. Cut ears from construction paper; wrap ends that will be inserted into cake with plastic food wrap. Press into notch on top. Use jelly beans for eyes and nose.
• Shake 1 cup coconut and 3 drops food color in tightly covered jar until evenly tinted. Surround bunny with tinted coconut. Add additional jelly beans if desired. Remove ears, plastic wrap and toothpicks before serving. Store loosely covered.

Steps:

• For the frosting: Combine the sugar, butter and salt in the bowl of a stand mixer fitted with a paddle attachment (or in a large bowl if using a hand-held electric mixer). Mix on low speed until mostly incorporated. Add the vanilla, increase the speed to medium high and mix until smooth. Adjust the consistency with milk until the frosting is easy to spread.
• For the bunny: Spread a thin layer of frosting (about 2/3 cup) on the flat side of one cake layer and top with the flat side of the second cake layer. Measure 5 inches across the top of the cake and cut down through the layers, creating 2 layered pieces that are slightly different sizes.
• Place the larger piece of cake cut-side down on a large platter or cake board. If using a rectangular cake board, place the larger piece so that the long edges are parallel with the long edges of the board. This is the body of the bunny. Cut the smaller piece of cake in half crosswise, so you have 2 layered wedges. Place one wedge in front of the body, with one flat side on the board and the other flat side against the body. The curved side will be on top. Take a serrated knife and round off the sharp edges on top of the head. Cut the tip off (the nose) at a 45-degree angle. Reserve all scraps in a bowl.
• Separate the layers of the remaining wedge of cake. These will be the back legs. Round the sharp edges of the cake wedges with your knife and add to the scrap bowl. Place one piece on each side of the bunny, with one flat side down and the other flat side facing forward (the round side towards the back of the bunny), about 1 inch from the end of the bunny's body.
• Mix the cake scraps in the bowl with a fork until mashed and then pack into a ball with your hands. Place the ball behind the bunny's body and adhere with a dab of frosting. This is the bunny's tail.
• Frost the entire bunny, tail and all, using 2 to 3 cups of the frosting, keeping some definition with the bunny parts and frosting more generously around any sharp edges to give a rounded look to the bunny parts. Sprinkle the bunny with the coconut to fully cover. Gently pat to adhere.
• Insert the biscotti between the head and body, pressing into the cake to secure them. These are the ears. Place the base of the ears close together at the center of the head and angle them out. Frost the front of each biscotti with some frosting. Then, using the pink decorating icing, frost a smaller strip in the center of each biscotti, going down to where the ears meet the head but not going all the way to the top.
• To make the face, press a black jelly bean into each side of the head for the eyes. Cut one of the marshmallows into 3 circles, discard the middle piece and press the 2 end circles, cut-sides in, into the front of the face for the bunny cheeks. Push the white jelly bean halves into the face below the cheeks, round-sides out, for the teeth. Place the pink jelly bean above for the nose.
• Unroll the licorice wheel and cut 2 pieces, each about 1 1/2 inches long. For each piece, peel the strips apart halfway down and then cut each separated strip in half lengthwise so you end up with a piece looking a bit like a broom. Repeat with the second piece of licorice. Tuck each piece, with a dab of frosting, behind a marshmallow cheek, with the cut ends facing out for the whiskers.
• Cut the second marshmallow in half lengthwise. Make 3 slits in each half, going about halfway through (these are the toes), and place in front of the legs for the bunny's feet. Adhere the bottom of the feet with frosting if necessary.

Steps:

• Leave 1 cake whole. Use serrated knife to cut remaining cake into 3 pieces as shown in video. Arrange on large foil-covered board or platter to resemble a bunny's head and bow tie, using small amount of COOL WHIP to attach pieces to each other.
• Frost cake with remaining COOL WHIP.
• Sprinkle with coconut. Decorate with remaining ingredients as shown in photo. Keep refrigerated.