Holiday Cake Pops Recipes

Steps:

• Place about 1/4 cup of candy melts into a small microwave-safe bowl, and melt in the microwave at 40 percent power for 30 seconds; stir the candy coating, and continue to heat for 30 second-intervals until the coating is just warm and completely melted.
• Poke a hole halfway through a doughnut hole with a lollipop stick, then dip the end of the stick into the melted coating and reinsert into the hole. This holds the doughnut hole firmly on the stick. Stick the doughnut pop upright into a block of plastic foam, and set into refrigerator for 1 hour to firm up.
• When pops are firmly attached to their sticks, melt the remaining candy coating dots in a microwave-safe bowl on 40 percent power for 1 minute; stir, and melt for 30-second intervals until the coating is warm and smoothly melted. Dip the doughnut hole into the coating, covering it completely. Hold the dipped pop over a bowl, and sprinkle with colored candy sprinkles. Return the decorated pops to the plastic foam block to set.

Steps:

• Prepare and bake the cake according to the package directions for a 9-by-13-inch pan. Let cool completely.
• Break the cake into pieces and place it in a food processor. Add the frosting and process until the mixture forms a ball and pulls away from the sides of the bowl, about 30 seconds. If the mixture doesn't come together, add more frosting 1 tablespoon at a time until it holds its shape.
• Using a 3/4-ounce scoop, form the mixture into 46 balls and put them on a baking sheet. Refrigerate until firm, about 30 minutes.
• Meanwhile, place the candy wafers in a microwave-safe bowl and melt according to package directions. Dip a half inch of the tip of a lollipop stick into the candy and then stick the tip halfway into a cake ball. Repeat with the remaining balls and sticks. Refrigerate the cake pops until completely chilled, about 1 hour.
• Microwave the candy again until melted and pour it into a tall narrow glass. Dip each cake pop into the candy and let any excess run off. If decorating, turn the cake pop upright and sprinkle with sprinkles while the coating is still wet. Stick the finished pops in two 9.8-by-11.8-inch Styrofoam blocks block and let set completely.