Jello Beans Recipes

Steps:

• Spray inside of bean mold with cooking spray. Place mold, fill side up, on tray.
• Add boiling water to gelatin mixes in large bowl; stir 3 min. until completely dissolved. Pour into measuring cup with pour spout. Immediately pour into mold, filling each bean completely. (Any remaining gelatin mixture can be poured into custard cup.)
• Refrigerate 30 min. or until firm. Tilt mold on slight angle over plate. Using moist fingertips, gently scoop beans out of mold. Keep refrigerated.

Steps:

• Using no stick cooking spray, lightly spray inside of bean mold. Or dip paper towel in vegetable oil and lightly wipe inside of bean mold. Place mold, fill-side up, on tray. Stir boiling water into gelatin in bowl at least 3 minutes until completely dissolved. Pour into liquid measuring cup. Slowly pour gelatin into mold, filling each bean completely. Refrigerate 30 minutes or until firm. Tilt mold on slight angle over plate. Using moist fingertips, gently scoop beans out of mold. Refrigerate until ready to serve.

Steps:

• Preheat the oven to 325 degrees F (165 degrees C). Butter 2 cookie sheets.
• Beat butter and sugars together using an electric mixer until creamy. Beat in egg, salt, baking soda, baking powder, and vanilla extract. Stir in flour and oats until just blended. Fold in jelly beans.
• Drop rounded spoonfuls of the cookie dough about 2 inches apart onto the prepared cookie sheets.
• Bake in the preheated oven until edges are golden, 9 to 10 minutes.

Steps:

• 1. 1. In a large saucepan on medium heat, combine 3/4 cup water, 1 1/4 cups sugar, and gelatin. 2. Bring to a boil, stirring regularly to ensure that no clumps of gelatin form. 3. As soon as the temperature reaches 230 F, take the pot off the burner - the syrup should still be quite liquidy. This should not take more than 25 minutes. If your syrup gets any hotter than 230 F, it will make your jelly beans too hard. 4. Set the pot in a bowl of ice to stop the temperature from rising. If you don't have a bowl bigger than your pot, just fill your sink with ice water and put the pot in there. 5. Quickly stir in the juice (or booze) and salt.
• 2. 6. Spray the jelly bean molds with non-stick spray and pour the syrup into the molds. I found that it was better to overfill the molds than to underfill them. The beans that I underfilled a little bit were harder to remove from the molds. 7. Let the jelly beans sit for four to six hours, or until the gelatin has hardened. It will still be gummy and sticky. 8. Pop the jelly beans out of the molds and transfer them to parchment paper. This part is a little bit tricky. I used a small spoon to dig them out. The great thing is that the beans are very forgiving. Don't worry too much about mangling them when you remove them, as they hold their shapes surprisingly well. 9. Lightly dust the beans with cornstarch to help them dry. Let them sit for another few hours. 10. To make the outer shell, mix 1/4 cup water, 3/4 cup sugar, and whatever food coloring you like.
• 3. 11. Pour the mixture into a jar along with the jelly beans, as shown above. 12. Seal the jar tightly. Tilt the jar at an angle (like a slide) and turn it in your hand (as you would a doorknob), preserving the angle. The goal is to make a mock version of a tumbler (a tool used for coating candy - that at $700 is cost-prohibitive for the average home baker) that allows the sugar to gradually build up and evenly coat the jelly beans. This step is extremely important. If the candy is not well-coated, it will not have a hard outer shell. Tumble for 10-15 minutes. This, my friends, is the workout portion of your candy making experience. 13. Fish the coated beans out of the liquid and place them on fresh parchment to dry and harden overnight. 14. Once the top side is hard, flip each bean and allow the other side to dry.