Serviettenapkin Folding A Simple Elegant Cylinder Recipes

Steps:

• Lay your serviette square out flat before you.
• Fold the top and bottom left hand edges to meet the top and bottom right hand edges. You will have a long rectangle with the fold on the left hand edge.
• Fold the bottom short edge up about 1/3 of the way up the rectangle. Then repeat another 1/3 of the way up.
• Carefully turn the serviette over and fold the top and bottom East edge to the centre.
• Repeat with the West edge.
• Carefully turn this over again and you will have a neat package that has a pocket at the bottom into which a nametag, cutlery, flowers or a small gift can be inserted.

Steps:

• Lay your serviette square out flat before you in a diamond shape. Bring the bottom "South" point up to the "north" point of the diamond shape and you will now have a triangle shape with the crease at the bottom.
• Depending on how big your serviettes are, fold 1 1/2 to 2 1/2 inches (4-7 cm) back undernieth the fold edge of the triangle. The bigger the serviette the deeper this fold will be.
• Take the "east" point of the triangle and start rolling it up towards the "west" point of the triangle. When you get to the "west" edge tuck the "west" edge into to pleat that forms at the bottom.
• Turn the serviette over so that the neat front side is showing.
• A small bloom can be inserted into the pleat at the bottom if you wish.

Steps:

• Lay your serviette square out flat before you in the shape of the square.
• Fold the bottom left and right corners up to meet the top left and right corners so that you now have a rectangle shape with the crease at the bottom.
• Take the top and bottom right corners and roll them all the way to the left top and bottom corners.
• Slip the serviette ring over the rolled end and bring up to the half way point. Set the serviette on a plate with the join at the back and the closed neat part of the roll facing the top.

Steps:

• Lay your serviette square out flat before you in a square shape.
• Fold the bottom left and right corners to meet the top left and right corners. You will now have a rectangle with the crease along the bottom edge.
• Place your finger at the center of the top edge, with your other hand fold the bottom right hand corner to meet your finger.
• Now take the very top right hand corner, and fold it to the very top left hand corner. You should now have a square shape with a diagonal line running from top left to bottom right.
• Take the bottom left hand corner and fold it up to the top right and corner.You will now have a right-angle triangle (the right-angle being in the top right hand corner).
• Pick up the serviette so that the right-angle is facing away from you in the North position. Carefully open the inside folds so that you have something that resembles an ice cream cone (but with one side of the top higher than the other)The side closest to you will have all 4 loose corners visible.
• The side with the right-angle triangle will be the lowest point of the cone shape. Grasp this place ( it's also where the join is) firmly and carefully turn it it a little inside out, so that a small cuff is made all the way around. The bottom of your ice cream cone is now an elegant cone shaped sail and the cuff rises at one end like a little boat.

Steps:

• Lay your serviette square out flat before you. Fold it in half horizontally.
• Take the serviette and fold it in half again vertically so that it is now a small square a quarter the size of the origonal square.
• Only one corner of the square will have 4 open / loose edges, rotate your square so that it is a flat diamond shape with the open corner pointing downwards. We will call this the "South" corner, and the top corner opposite "North" and the other two remaining corners East and West.
• Fold the South corner up, so that it meeting and laying on top of the North corner. Your serviette is now in the form of a triangle.
• Gently crease the bottom ( east /west line) of the triangle well.
• The South corner consists of 4 seperate flaps, take only the outer-most of these and fold it back south again, expect that the crease line should be about 1/2 inch (1 cm) HIGHER ( but still parallel to) the bottom ( east/west) straight edge of the triangle. This leaves a thick triangle on the top and a very thin, one paper layer, smaller triangle on the bottom.
• Take the next layer of the loose flap at North, and fold it south, with it's crease line about 1/2 inch (1 cm) ABOVE the crease line from the first folded down flap. Now you will have a smaller triangle folded down in the South position on top of the first one.
• Repeat Step 7 until all four flaps are folded down, pointing South in triangles on top of each other, the one on the bottom will be the biggest and the one on the top will be the smallest.
• Carefully pick up the serviette and bring the East and West corners together at the back, then carefully crease firmly the fold that runs from the center of the top main triangle to the point at North.
• Turn the serviette around and set the finished serviette onto the table with the North point closest to you on the table, with East and West points on the table furthest away from you and the South points pointing up into the air up the center.
• Works best wih heavier paper serviettes.

Steps:

• Lay your serviette square out flat before you. Fold it in half horizontally.
• Take the serviette and fold it in half again vertically so that it is now a small square a quarter the size of the origonal square.
• Only one corner of the square will have 4 open / loose edges, rotate your square so that it is a flat diamond shape with the open corner pointing downwards. We will call this the South corner, and the top corner opposite North.
• Grasp your serviette about 2/3 of the ways up and starting at point that is on the East side of your serviette, make 5 folds or pleats more or less the same size, folding/ pleating towards from the East point to the West point.
• Slip your Serviette Ring over the north point and gently pull downwards so that only the top 1/3 of the serviette goes though the ring. Keep the north point of the serviette nicely centered.
• Spread the bottom half out the serviette into a fan formation so that both halves are equal and it looks pleasingly balanced.The top of the serviette should taper gently up to the North point and if wanted a small flower can be inserted into the fold at the top and down into the napkin ring.
• Place on empty plate.

Steps:

• Lay your serviette out flat and square before you.
• Take the top and bottom left hand corners and fold them over to the top and bottom right hand corners so that you now have a vertical rectangle before you, with the crease on the left.
• Starting at the bottom left and bottom right corners, accordion fold the serviette upwards to just past the half way point of the rectangle. (ironing the folds helps them to keep their shape).
• Now take the right side corner edge of the accordion folded strip and fold it over to the left side corner edge of the accordion strip so that the strip is now folded in half. There will be a square shape that is folded in half hanging out at the back.
• Holding the folded accordion pleats firmly, take hold of the top right corner of the square flap at the back (this corner has two open points, no fold line) and fold it over to meet the bottom left point of the square (right next to the accordion fold where it is folded in half), it should overlap the bottom of the square just a little.
• Now take that little overlapping flap and tuck it under the bottom of the square, that should secure things so that the serviette will stand up well.
• Carefully stand the serviette up and fan out the accordion pleats, the square part will be at right angles out at the back and stabilizes the fan as it stands up.
• Present it standing on a plate.