Serviettenapkin Folding Elegant Sail Recipes

Steps:

• Lay your serviette square out flat before you in a square shape.
• Fold the bottom left and right corners to meet the top left and right corners. You will now have a rectangle with the crease along the bottom edge.
• Place your finger at the center of the top edge, with your other hand fold the bottom right hand corner to meet your finger.
• Now take the very top right hand corner, and fold it to the very top left hand corner. You should now have a square shape with a diagonal line running from top left to bottom right.
• Take the bottom left hand corner and fold it up to the top right and corner.You will now have a right-angle triangle (the right-angle being in the top right hand corner).
• Pick up the serviette so that the right-angle is facing away from you in the North position. Carefully open the inside folds so that you have something that resembles an ice cream cone (but with one side of the top higher than the other)The side closest to you will have all 4 loose corners visible.
• The side with the right-angle triangle will be the lowest point of the cone shape. Grasp this place ( it's also where the join is) firmly and carefully turn it it a little inside out, so that a small cuff is made all the way around. The bottom of your ice cream cone is now an elegant cone shaped sail and the cuff rises at one end like a little boat.

Steps:

• Take your square napkin, lay it totally flat before you, then fold it in half horizontally.
• Fold again, this time vertically so that you have before you a square a quarter the size of your origonal square.
• Only one of the 4 corners will have 4 open or loose edges. Rotate the square before you so that it looks like a diamond with the four open edges pointing to the bottom.
• We will call the points on your diamond shape East, West, North and the open egded bit, South.
• Make a horizontal fold between the East/West points, bringing the open ended South point up to meet, and on top of, the North point.You will now have a little triangle.
• Take the East point of the triangle and fold it in towards the middle. What was the sloping right hand edge of the triangle is now a vertical edge running down the center of the triangle and there is a little flap sticking out at the bottom.
• Take the West point and fold it into the center the same as you did with the previous East edge, the two vertical lines should meet in the middle, and you will have a diamond shape that has two long sides at the top and two short sides (the two little flaps) at the bottom.
• Pick up your diamond shape and fold the two little flap bits at the bottom completely under, so that they only show on the back of the triangle. The front will now look like a steep triangle with a vertical slit down the middle.
• We will call the points of this triangle East, West and North. With the flaps still folded to the back of the tiangle, fold the East and West points backwards until they meet, and gently crease the two folds that form and meet at the North point.
• The slit in the front will have opened and the 4 open points of the napkin will be hidden in layers inside. Pull very gently on them one by one and they will stand up like the sails of a boat. Some people I know call this napkin a boat, some a flower and some the Sydney Opera House.I don't know its' offical name but set onto a plate or into an empty wine glass, this a very elegant addition to a classy table setting.

Steps:

• Lay your serviette square out flat before you in a diamond shape. Bring the bottom "South" point up to the "north" point of the diamond shape and you will now have a triangle shape with the crease at the bottom.
• Depending on how big your serviettes are, fold 1 1/2 to 2 1/2 inches (4-7 cm) back undernieth the fold edge of the triangle. The bigger the serviette the deeper this fold will be.
• Take the "east" point of the triangle and start rolling it up towards the "west" point of the triangle. When you get to the "west" edge tuck the "west" edge into to pleat that forms at the bottom.
• Turn the serviette over so that the neat front side is showing.
• A small bloom can be inserted into the pleat at the bottom if you wish.

Steps:

• Lay your serviette out flat before you in a diamond shape.
• Take your finger and place it half way between the West and South points, and about 1 inch toward the centre of the serviette. Next, Take the East point at bring it to the point where your finger is. Don't crease this fold (yet).
• Now take the West point of the serviette and bring it over to the East side so that both sides of this new diamons shape are even. Youmay have to adjust the first fold a little to get it looking good, once they are both ok, you can crease both the folds.
• You will have a very fat tie shape.
• Repeat the previous step again completely and you will have a smaller tie shape in front of you now.
• Take the top third of the tie (the narrowest bit) and fold it under and over itself horizontally (the end tip should be tucked undernieth) and the top should now look like the knot of a formal neck tie.
• Place on a plate and surprise the men in your life!

Steps:

• Lay your serviette square out flat before you.
• Take the bottom right and left corners and make an accordion fold strips all the way up to the top right and left corners. If you press these with an iron the pleats will be nice and sharp. Leave unironed for a wavy casual look. (but ironed looks neater) You will now have a thin band the width of your accordion fold.
• Fold the serviette in half so that is is now half it's length and slip a serviette ring over the fold end of the accordion strip and pull gently about 1 inch ( 2.5 cm) up.
• Fan out the accordion pleats at the top to make a pleasing balance to the serviette. Present on a plate.

Steps:

• Lay your serviette out flat before you in a diamond shape.
• Fold the South point of the diamond up to meet the North point of the diamond.
• Turn the serviette so that the crease is vertical on the left side and the point points out to the right.
• Bring the top point of the napkin diagonally towards you and to the right so that the crease falls an inch (2.5cm) or so short of the right-most corner and the newly formed point at the bottom is a few inches (5-6 cm) to the right of the left one.
• Fold the right-most point towards you, the top point remains in the same place as before and the bottom comes about half way along the remaining edge. This creates two neat triangles and a diamond shape and a very simple but elegant serviette.

Steps:

• Lay your serviette square out flat before you. Fold it in half horizontally.
• Take the serviette and fold it in half again vertically so that it is now a small square a quarter the size of the origonal square.
• Only one corner of the square will have 4 open / loose edges, rotate your square so that it is a flat diamond shape with the open corner pointing downwards. We will call this the South corner, and the top corner opposite North.
• Grasp your serviette about 2/3 of the ways up and starting at point that is on the East side of your serviette, make 5 folds or pleats more or less the same size, folding/ pleating towards from the East point to the West point.
• Slip your Serviette Ring over the north point and gently pull downwards so that only the top 1/3 of the serviette goes though the ring. Keep the north point of the serviette nicely centered.
• Spread the bottom half out the serviette into a fan formation so that both halves are equal and it looks pleasingly balanced.The top of the serviette should taper gently up to the North point and if wanted a small flower can be inserted into the fold at the top and down into the napkin ring.
• Place on empty plate.

Steps:

• Lay your serviette square out flat before you. Fold it in half horizontally.
• Take the serviette and fold it in half again vertically so that it is now a small square a quarter the size of the origonal square.
• Only one corner of the square will have 4 open / loose edges, rotate your square so that it is a flat diamond shape with the open corner pointing downwards. We will call this the South corner, and the top corner opposite North.
• Take the uppermost of the loose points at the South position and fold it up to meet the North point.
• Take the next loose point at South position and also fold it towards the north point but stop short of it so that you have a triangle within a triangle.
• Repeat with the remaining two loose points so that you now have a set of ever decreasing triangles on the front of your triangular serviette. If you have time, press these with an iron so that you have crisp sharp creases ( this does improve the result immensely).
• Carefuly turn the serviette over and take the bottom right point and bring it up to a central point midway along the edge between the bottom left point and the top at North.
• Repeat with the remaining corner. Iron the creases.
• Turn the serviette over again to show off the neat front side.

Steps:

• Lay your serviette square out flat before you.
• Fold the top and bottom left hand edges to meet the top and bottom right hand edges. You will have a long rectangle with the fold on the left hand edge.
• Fold the bottom short edge up about 1/3 of the way up the rectangle. Then repeat another 1/3 of the way up.
• Carefully turn the serviette over and fold the top and bottom East edge to the centre.
• Repeat with the West edge.
• Carefully turn this over again and you will have a neat package that has a pocket at the bottom into which a nametag, cutlery, flowers or a small gift can be inserted.

Steps:

• Lay your serviette square out flat before you in the shape of the square.
• Fold the bottom left and right corners up to meet the top left and right corners so that you now have a rectangle shape with the crease at the bottom.
• Take the top and bottom right corners and roll them all the way to the left top and bottom corners.
• Slip the serviette ring over the rolled end and bring up to the half way point. Set the serviette on a plate with the join at the back and the closed neat part of the roll facing the top.