Watermelon Bowl Recipes

Steps:

• To carve melon bowl, cut off top 1/4 of melon. Being careful not to cut through to melon, cut thin slice from bottom of melon so it will sit flat. Scoop out watermelon, leaving 1/2- to 1-inch-thick shell.
• Carve watermelon as shown in steps on right. Wrap melon bowl in plastic wrap to keep moist; refrigerate until ready to fill. At serving time, fill with cut-up fruit.

Steps:

• Using a large chef's knife, cut both watermelons in half lengthwise through the stem. With a melon half flesh side up, cut vertical lines into the flesh (leaving rind intact) 1 inch apart and about 2 inches deep along the length of each half, leaving a 1-inch border of flesh on both ends. Repeat this process with the lines going in the opposite direction. Use a spoon to scoop out the watermelon pieces into a large bowl (it's okay if some of the spears break in half as you are doing this.) Repeat with the remaining melon halves. Use the spoon to remove as much of the flesh left in the watermelon halves as possible and save for another use.
• Cut 1 1/2 inches off both ends of 2 of the watermelon halves (these halves will become the middle parts of the bowl). Cut 1 1/2 inches off one end of the 2 remaining halves (these will become the bookends of your bowl). Use the flesh left in the watermelon ends to stamp out sharks with a 3-inch shark cookie cutter and set aside.
• Use a metal skewer to outline waves along the top edge of each watermelon half. Then carefully cut out the wave pattern using a sharp paring knife. Take one middle piece and one bookend piece and place the flat sides together to create half of the large bowl. Thread the metal skewer through the bottom of the watermelons to secure them together. Repeat this process with the remaining watermelon halves and another metal skewer to create the other half of the large bowl. Place both halves on a large platter with the two middle pieces pushed together (these parts do not need to be secured with a skewer as they will stay together on the platter).
• Fill the assembled watermelon bowl with the reserved watermelon chunks. Mix the berries and grapes together and scatter on top of the watermelon, covering it as much as possible, then add the melon sharks.

Steps:

• Add all the ingredients to a blender and mix on high.
• Pour into a bowl or half a hollowed out small watermelon, and top with desired fruit and other toppings.
• Enjoy!

Steps:

• Using a sharp knife, cut around the watermelon slices rind to remove, then dice into 1-inch (2 cm) cubes.
• Transfer 4 cups (600 g) to a medium bowl, reserving the rest for another use.
• In a small bowl, combine the soy sauce, rice vinegar, sesame oil, lime juice, agave, scallions, ginger, white sesame seeds, and chile flakes. Mix well.
• Pour the marinade over the watermelon cubes and stir. Cover the bowl with plastic wrap and let marinate in the fridge for 1 hour.
• Slice the cucumber into thin half moons and set aside.
• In a small bowl, combine the mayo and Sriracha.
• To assemble the poke bowls, start with rice as a base and top with cucumbers, avocado, edamame, nori, pickled ginger, Sriracha mayo, cilantro, and crushed peanuts.
• Add a scoop of the marinated watermelon and use the marinade as a dressing to drizzle over the bowl.
• Garnish with black sesame seeds, if desired.
• Enjoy!

Steps:

• Cut top third off watermelon; trim bottomjust enough to make a flat surface. Scoopout flesh.
• Working in batches, pureewatermelon in a food processor. Strainthrough a fine sieve; discard solids.(You should have about 9 cups juice.)Cover rind with plastic wrap. Refrigeratejuice and rind until chilled, about1 hour. Combine juice with seltzer; transfer to rind.