Classic Peppermint Bark Recipes

Steps:

• Coat a 9-by-12 1/2-inch rimmed baking sheet or 6 small loaf pans (2 1/2 by 5 inches) with cooking spray, and line with parchment, leaving an overhang on long sides. Pour melted chocolate into baking sheet or divide among pans (3 tablespoons each), and spread in an even layer. Sprinkle toppings over chocolate. Refrigerate until firm, at least 1 hour. Peel off parchment, and break bark into pieces.

Steps:

• Cover cookie sheet with waxed paper, aluminum foil or cooking parchment paper. Place candy coating in 8-cup microwavable measure or 2-quart microwavable casserole. Microwave uncovered on High 2 to 3 minutes, stirring every 30 seconds, until almost melted. Stir until smooth.
• Place peppermint candies in heavy plastic bag; crush with rolling pin or bottom of small heavy saucepan. Pour crushed candies into wire strainer. Shake strainer over melted coating until all of the tiniest candy pieces fall into the coating; reserve the larger candy pieces. Stir coating to mix evenly. Spread coating evenly on cookie sheet. Sprinkle evenly with remaining candy pieces. Let stand about 1 hour or until cool and hardened. Break into pieces. Chocolate-Peppermint Bark: Substitute chocolate-flavored candy coating for the vanilla candy coating. Drizzled Peppermint Bark: Heat 1/2 cup semisweet chocolate chips or white baking chips and 1 teaspoon shortening until melted. Drizzle over Peppermint Bark before letting stand 1 hour.

Steps:

• Line a 9-by-13-inch baking dish with aluminum foil, shiny-side up; smooth out any wrinkles. Heat 1 inch of water in a saucepan over low heat until steaming.
• Put all but 3/4 cup of the semisweet chocolate in a heatproof bowl. Set the bowl over the saucepan of steaming water (do not let the bowl touch the water) and stir until one-third of the chocolate is melted. Remove the bowl from the saucepan; keep the steaming water over low heat. Gradually stir the reserved 3/4 cup semisweet chocolate into the bowl, a few pieces at a time, until all of the chocolate is melted. Return the bowl to the saucepan, 5 to 10 seconds at a time, to help melt the chocolate, if needed. Do not rush this step: It may take up to 10 minutes to melt the chocolate.
• Wipe off any moisture from the bottom of the bowl. Stir 3/4 teaspoon peppermint extract into the chocolate, then quickly pour into the prepared baking dish and spread in an even layer. Firmly tap the dish against the counter to remove any air bubbles. Set aside at room temperature until almost set, about 10 minutes.
• Meanwhile, put all but 1 cup of the white chocolate in a large heatproof bowl and repeat the melting process over the steaming water; dry off the bottom of the bowl. Stir in the remaining 3/4 teaspoon peppermint extract; pour over the semisweet chocolate and spread in an even layer. Sprinkle immediately with the crushed candy canes, gently pressing them into the white chocolate. Set aside at room temperature until firm, about 1 hour. Lift the bark out of the pan using the foil and break it into pieces. Store in an airtight container at room temperature for up to 2 weeks.

Steps:

• Spread 1/3 of the peppermint candy over a 9x13-inch baking pan lined with wax paper.
• Melt the milk chocolate in the top of a double boiler over just-barely simmering water, stirring frequently and scraping down the sides with a rubber spatula to avoid scorching, just until melted. Pour the melted chocolate over peppermint candy in the prepared pan. Sprinkle another 1/3 of the candy on top of the milk chocolate. Refrigerate until the chocolate hardens, about 30 minutes.
• Melt the white chocolate in the top of a double boiler over just-barely simmering water, stirring frequently and scraping down the sides with a rubber spatula to avoid scorching. Stir in the oil-based peppermint flavoring. Pour the white chocolate over the milk chocolate, then spread the remaining 1/3 peppermint candy on top.
• Refrigerate until the white chocolate hardens, about 30 minutes. Cut or break into pieces to serve.