Fresh Pasta Squares Recipes

Steps:

• Mound the flour in the center of a large, wide mixing bowl. Dig a well in the center of the mound and add eggs and yolks. Using a fork, beat together the eggs and begin to incorporate the flour, starting with the inner rim of the well. The dough will start to come together in a shaggy mass when about half of the flour is incorporated.
• Use your fingers to continue to mix the dough. Press any loose bits of flour into the mass of dough. If needed, add another egg yolk or a tablespoon of water to absorb all of the flour. Once the dough comes together into a cohesive mass, remove it from the bowl.
• Transfer to a lightly floured surface and knead by hand for 4 to 5 more minutes until the dough is smooth, elastic and uniform in color. Wrap the dough in plastic and set aside for at least 30 minutes (and up to 4 hours) at room temperature.
• Line three baking sheets with parchment paper and lightly dust with semolina flour. Set aside.
• Cut off a quarter of the dough. Rewrap rest, and set aside. Use the heel of your hand to flatten the dough into an oval approximately the same width as your pasta machine, about six inches. Set the rollers to their widest setting and pass the dough through.
• Lay the dough out onto a lightly floured cutting board or countertop and neatly press together into halves, so it's again about the same width of the pasta machine. Feed the pasta through again at the widest setting. Think of these first rollings as an extended kneading. Continue to fold the dough in thirds and roll it until it is smooth, silky and even-textured. Do your best to make the sheet the full width of the machine.
• Once the dough is silky and smooth, you can begin to roll it out more thinly. Roll it once through each of the next two or three settings, adding flour as needed, until the dough is about 1/4-inch thick.
• Once the pasta is about 1/4-inch thick, begin rolling it twice through each setting. As you roll, lightly sprinkle all-purpose or 00 flour on both sides of the pasta to prevent it from sticking to itself.
• Roll out pasta until you can just see the outline of your hand when you hold it under a sheet, about 1/16-inch thick for noodles, or 1/32-inch thick for a filled pasta. (On most machines, you won't make it to the thinnest setting.)
• Cut pasta into sheets, about 12 to 14 inches long. Dust the sheets lightly with semolina flour and stack on one of the prepared baking sheets and cover with a clean, lightly dampened kitchen towel. Repeat with remaining dough.

Steps:

• Beat together the eggs, yolk and olive oil with a fork in a large spouted measuring cup.
• Combine the flour and a large pinch of kosher salt in the bowl of a food processor. Pulse briefly to combine. With the food processor motor running, gradually pour the egg mixture through the feed tube and let it run until the dough forms a ball around the blade. (If the dough is too sticky to form a ball, add a tablespoon or so of flour and process again. If it is too crumbly to form a ball, add cold water, 1 tablespoon at a time, and process again.) Once the dough forms a ball, process until smooth and springy, 20 to 30 seconds.
• Transfer the dough to a floured work surface and knead several times, until the dough comes together in a smooth ball.
• Wrap the dough in plastic wrap and let it rest at room temperature for 30 minutes. (The dough can be made 1 day ahead, wrapped and refrigerated. Let it come to room temperature before rolling.)
• Anchor a pasta machine to your countertop or secure the pasta attachment to a stand mixer. Set the machine to the widest setting. Unwrap the dough and cut it into 4 equal pieces. Wrap 3 of the pieces while you work with the fourth.
• Flatten the dough into a rectangle and lightly dust with flour. Roll it through the pasta machine at the widest setting. Fold the dough in thirds like a letter and feed it through the pasta machine. Repeat the folding and feeding of the dough through the machine 2 more times. (Rolling and folding in this manner will help strengthen and smooth the dough.)
• Set the pasta machine to the next setting (one setting thinner than the widest). Flour the dough as necessary and feed it through the machine. Repeat, feeding it through one more time.
• Adjust the machine to the next thinnest setting and feed the dough through 2 times as above. Continue changing the setting and feeding the dough through 2 times for each setting until you have fed the dough through the second-to-last setting. The dough should be thin enough so that you can see your hand through it.
• If you are cutting your pasta into noodles: Stop rolling the dough through after you have gone through the second-to-last setting.
• If you are making filled pasta, like ravioli: Change the machine to the final setting and feed the dough through.
• Cut the dough in half crosswise and cover it with plastic wrap. Repeat the folding, rolling and cutting process with the 3 remaining pieces of dough. Cover each piece of dough as you finish. You should have 8 pieces of dough total.
• If you are cutting your pasta into noodles: Affix the cutting attachment to the pasta machine. Choose the desired setting and feed the dough through. Lightly toss the noodles with a little flour on a baking sheet to prevent sticking and cover with a dry kitchen towel while you process the rest of the dough. Cook the noodles in a large pot of boiling salted water until al dente, 3 to 4 minutes.
• If you are making filled pasta: Proceed according to your recipe's instructions.

Steps:

• Make dough:
• Blend all ingredients in a food processor until mixture just begins to form a ball. Knead dough on a lightly floured surface, incorporating only as much additional flour as necessary to keep dough from sticking, until smooth and elastic, 6 to 8 minutes. Wrap dough in plastic wrap and let stand 1 hour.
• Roll out dough:
• Set smooth rollers of pasta machine at widest setting. Cut dough into 4 pieces and keep 3 pieces covered. Flatten unwrapped piece of dough into a rectangle and feed through rollers. Fold rectangle in half and feed through rollers 8 more times, folding in half each time and dusting with flour as necessary to prevent sticking.
• Turn dial to next (narrower) setting and feed dough through without folding. Continue to feed dough through without folding, making space between rollers narrower each time, until narrowest setting is used. Cut rolled-out dough into 31/2-inch squares. Gather trimmings into a ball and wrap in plastic wrap. Transfer squares to a wax-paper-lined baking sheet and cover with plastic wrap. Roll out and cut remaining dough in same manner, then repeat with trimmings.