Sleepy Hollow Peppermint Bark Recipes

Steps:

• Lightly grease a 9x9 inch pan and line with waxed paper, smoothing out wrinkles; set aside.
• Place the semisweet chocolate and 1 teaspoon of the canola oil in the top of a double boiler over just barely simmering water, stirring frequently and scraping down the sides with a rubber spatula to avoid scorching. When the chocolate is melted, stir in 1/4 teaspoon of the peppermint extract.
• Pour the melted chocolate into the prepared pan, and spread evenly over the bottom of the pan. Sprinkle half of the crushed peppermints over the chocolate layer. Refrigerate until completely hardened, about 1 hour.
• Place the white chocolate and the remaining 1 teaspoon canola oil in the top of a double boiler over just barely simmering water, stirring frequently and scraping down the sides with a rubber spatula to avoid scorching. When the chocolate is melted, stir in the remaining 1/4 teaspoon peppermint extract.
• Pour the white chocolate directly over the semisweet chocolate layer; spread evenly. Sprinkle the remaining crushed candy over the top and gently press in. Refrigerate until completely hardened. Remove from pan; break into small pieces to serve.

Steps:

• Line a 9-by-13-inch baking dish with aluminum foil, shiny-side up; smooth out any wrinkles. Heat 1 inch of water in a saucepan over low heat until steaming.
• Put all but 3/4 cup of the semisweet chocolate in a heatproof bowl. Set the bowl over the saucepan of steaming water (do not let the bowl touch the water) and stir until one-third of the chocolate is melted. Remove the bowl from the saucepan; keep the steaming water over low heat. Gradually stir the reserved 3/4 cup semisweet chocolate into the bowl, a few pieces at a time, until all of the chocolate is melted. Return the bowl to the saucepan, 5 to 10 seconds at a time, to help melt the chocolate, if needed. Do not rush this step: It may take up to 10 minutes to melt the chocolate.
• Wipe off any moisture from the bottom of the bowl. Stir 3/4 teaspoon peppermint extract into the chocolate, then quickly pour into the prepared baking dish and spread in an even layer. Firmly tap the dish against the counter to remove any air bubbles. Set aside at room temperature until almost set, about 10 minutes.
• Meanwhile, put all but 1 cup of the white chocolate in a large heatproof bowl and repeat the melting process over the steaming water; dry off the bottom of the bowl. Stir in the remaining 3/4 teaspoon peppermint extract; pour over the semisweet chocolate and spread in an even layer. Sprinkle immediately with the crushed candy canes, gently pressing them into the white chocolate. Set aside at room temperature until firm, about 1 hour. Lift the bark out of the pan using the foil and break it into pieces. Store in an airtight container at room temperature for up to 2 weeks.

Steps:

• Heat oven to 310 degrees. Space out 15-20 unwrapped candies on two parchment lined baking sheets. (Keeping two baking sheets in the oven at a time ensures you constantly have something to work with and saves your rom just sitting there twiddling your thumbs.) Allow to melt just a bit (5-7 minutes) and pull out first sheet. You're going to be stretching and twisting the candies around one another to eventually shape a tree. If you're frustrated with how they're sticking or if anything breaks, simply heat with a Brûlée torch or handheld lighter for a moment and reapply. If you accidentally burn it (which I did several times), just toss it. Definitely use the torch at the base of your candy cane trunk before applying to stand-you want as sound a structure as you can get!
• Once you have your peppermint skeleton, now's the fun part of painting on the chocolate. Melt down chocolate in a double boiler until its just in a liquid state (110 degrees on candy thermomter is ideal for chocolate). GENTLY paint chocolate onto your skeleton, doing several coats and re-heating chocolate as needed. When desired affect is achieved, hand-paint several spare peppermint candies with black stripes and adhere using any extra chocolate.
• Using fine paint brushes, paint your tree with edible paints making highlights and low lights where they seem appropriate. Clean any mess from base using a warm clean cloth. Melt down white chocolate and pour into base to create clean smooth effect.

Steps:

• Spread 1/3 of the peppermint candy over a 9x13-inch baking pan lined with wax paper.
• Melt the milk chocolate in the top of a double boiler over just-barely simmering water, stirring frequently and scraping down the sides with a rubber spatula to avoid scorching, just until melted. Pour the melted chocolate over peppermint candy in the prepared pan. Sprinkle another 1/3 of the candy on top of the milk chocolate. Refrigerate until the chocolate hardens, about 30 minutes.
• Melt the white chocolate in the top of a double boiler over just-barely simmering water, stirring frequently and scraping down the sides with a rubber spatula to avoid scorching. Stir in the oil-based peppermint flavoring. Pour the white chocolate over the milk chocolate, then spread the remaining 1/3 peppermint candy on top.
• Refrigerate until the white chocolate hardens, about 30 minutes. Cut or break into pieces to serve.

Steps:

• Line a baking sheet with foil, shiny-side up; smooth out the creases. Make sure all your tools are dry.
• Chop the white chocolate into 1/2-inch pieces with a large knife. Place all but 1 cup of the chopped chocolate in a microwave-safe bowl. Microwave 30 seconds, then stir with a rubber spatula. Continue microwaving and stirring at 30-second intervals until melted, 3 to 5 minutes total. Immediately add the reserved chopped chocolate to the bowl; stir vigorously until melted and shiny. Don't worry if there are a few small unmelted pieces.
• Pour the white chocolate onto the prepared baking sheet; use the rubber spatula to spread it into a 10-to-12-inch circle, about 1/4 inch thick.
• Press the peppermints and marshmallows into the chocolate, arranging them so each bite has a mix of flavors and textures. Let the bark harden completely at room temperature, about 1 hour. (If the room is warm, you may need to freeze the bark for a few minutes.) Break into pieces and store in an airtight container at room temperature for 1 to 2 weeks.

Steps:

• Line a 9x12 pan with parchment paper.
• Melt the dark chocolate (use the method you prefer, either double boiler, or microwave - cook 30 seconds in a heat-proof bowl, stir and repeat until you have a smooth consistency.
• Pour the melted dark chocolate on the parchment paper, spread the chocolate out until it is about 1/3" thick. You can do this by hitting the pan on the countertop repeatedly, or maybe you could use a spatula to spread the chocolate.
• Melt the white chocolate, using the steps above. After the chocolate is smooth, pour it on top of the dark chocolate - trying to make the layers the same thickness. (it's best to do this step while the white chocolate is still very soft -- I've had them separate when I broke them into pieces, I think the layers "stick" together better if the white chocolate has not hardened).
• Unwrap the starlite mints, or peppermints of your choice and put them into a heavy duty ziplock bag. Using a hammer or meat tenderizer - crush the mints then, while the white chocolate is still melted sprinkle on top.
• Let the chocolates harden in the refrigerator for 2 hours, then break the candy into pieces. This needs to be stored in the refrgerator if you live in a warm/humid climate.

Steps:

• Melt chocolate over a double boiler. Stir in peppermint extract.
• Transfer to a pan lined with parchment and sprayed and spread in an even layer.
• Sprinkle on peppermint pieces.
• Refrigerate 1 hour, until firm.
• Break into pieces and enjoy!

Steps:

• Unwrap the candy canes and place in a freezer Zip-Loc bag then place it in another Zip-Loc bag.
• Using a hammer gently break up the candy canes into small pieces.
• Line an 11x17 baking sheet with aluminum foil.
• In a microwave safe bowl melt the dark wafers on low or defrost for 2 minutes then stir.
• Continue to melt on low in one minute increments stirring well until completely melted.
• Add 1/4 tsp + 1/8 tsp peppermint oil to melted chocolate stirring well.
• Pour onto foil lined baking sheet.
• Let sit for approximately 15 minutes.
• Do not refrigerate and do not let harden more than 15 minutes.
• While dark chocolate is hardening melt white wafers in the same manner as the dark chocolate.
• Add 1/2 tsp peppermint oil to melted wafers and crushed candy cane, stirring to mix well.
• Carefully pour over chocolate layer in pan distributing evenly.
• Very gently spread white layer evenly over chocolate layer.
• Let harden overnight or at least 4 hours then invert upside down to remove foil.
• Break into irregular pieces, not too small.
• If you try to break them into very small pieces the white tends to seperate from the dark.

Steps:

• Line a rimmed baking sheet with parchment paper and set aside. Set 12 ounces/340 grams semisweet chocolate in a microwave-safe bowl and microwave it in 5- to 25-second bursts, stirring occasionally, until it is melted and the temperature registers between 114 degrees and 118 degrees on an instant-read thermometer. Chocolate burns easily in the microwave, so go slowly. Try fewer seconds as the temperature starts getting close so that you don't overshoot the mark. (If you're a few degrees over, just keeping stirring the chocolate until it cools to the proper temperature.)
• Remove the bowl from the microwave and gradually stir in the remaining 4 ounces/115 grams semisweet chocolate until the temperature has come down to 88 to 89 degrees. (After a bit of practice you can actually see and feel the chocolate fall into temper. It takes on a slightly looser quality and becomes shinier. Be patient, this can take up to 10 to 12 minutes with some chocolate.) Now quickly pour the chocolate out onto the prepared pan and spread it into an even layer. Let the chocolate stand at room temperature until the layer has set, about 1 hour. (You can also refrigerate until set, about 30 minutes.)
• Now set 6 ounces/170 grams white chocolate in a microwave-safe bowl and microwave it in 5- to 25-second bursts, stirring occasionally, until it is melted and the temperature registers between 105 degrees and 110 degrees on an instant-read thermometer.
• Remove the bowl from the microwave and gradually stir in the remaining 2 ounces/55 grams white chocolate until the temperature has come down to about 85 degrees. Quickly stir in the peppermint extract. Drizzle the white chocolate mixture evenly over the semisweet chocolate. Immediately sprinkle with the candy cane.
• Let stand at room temperature until completely set, about 4 hours. To serve, break into pieces. Refrigerate leftover pieces as necessary.

Steps:

• Line baking sheet with waxed paper.
• Microwave morsels on medium high for 1 minute or until smooth.
• Place peppermint candies in a plastic bag and smash.
• While holding strainer over melted morsels pour crushed candies into strainer.
• Stir mixture.
• Spread mixture to desired thickness on baking sheet.
• Let stand for 1 hour or until firm.
• Break into pieces.