Wishbone Fried Chicken Recipes

Steps:

• Take your cut up chicken pieces and skin them if you prefer. Put the flour in a large plastic bag (let the amount of chicken you are cooking dictate the amount of flour you use). Season the flour with paprika, salt and pepper to taste (paprika helps to brown the chicken).
• Dip chicken pieces in buttermilk then, a few at a time, put them in the bag with the flour, seal the bag and shake to coat well. Place the coated chicken on a cookie sheet or tray, and cover with a clean dish towel or waxed paper. LET SIT UNTIL THE FLOUR IS OF A PASTE-LIKE CONSISTENCY. THIS IS CRUCIAL!
• Fill a large skillet (cast iron is best) about 1/3 to 1/2 full with vegetable oil. Heat until VERY hot. Put in as many chicken pieces as the skillet can hold. Brown the chicken in HOT oil on both sides. When browned, reduce heat and cover skillet; let cook for 30 minutes (the chicken will be cooked through but not crispy). Remove cover, raise heat again and continue to fry until crispy.
• Drain the fried chicken on paper towels. Depending on how much chicken you have, you may have to fry in a few shifts. Keep the finished chicken in a slightly warm oven while preparing the rest.

Steps:

• Preheat the oven to 200 degrees F. Fit cooling racks into 2 baking sheets.
• Place 1 chicken breast in a one-gallon resealable plastic bag with the seal left open (alternatively, place between 2 pieces of plastic wrap). Pound with a meat mallet or rolling pin until it is 1/4 to 1/2 inch thick. Repeat with the remaining chicken.
• Whisk together the flour, cornstarch, paprika, garlic powder, cayenne, 2 1/2 teaspoons salt and 1 teaspoon pepper in a shallow dish. Whisk together the buttermilk, hot sauce and egg in a medium bowl. Set up a dredging station by arranging the chicken, dry ingredients, wet ingredients and prepared baking sheet in an assembly line. Dredge 1 chicken breast in the dry ingredients to coat, then dip in the wet ingredients and shake off any excess. Dredge once again in the dry ingredients to coat and transfer to one of the cooling racks. Repeat with the remaining chicken.
• Fill a deep cast-iron skillet with 3/4 to 1 inch of oil. Heat the oil over medium-high heat until a deep-fry thermometer registers 350 degrees F. Working in 2 batches, fry the chicken until golden brown, 4 to 5 minutes per side. Place on the second cooling rack and keep warm in the oven until ready to serve.
• For the gravy: Melt the butter in a medium saucepan over medium heat. Add the flour and cook, whisking continuously, until light brown, about 2 minutes. Pour in the milk in a steady stream while whisking. Add 1 1/4 teaspoons salt and 1 teaspoon pepper, then the vinegar. Cook at a simmer, stirring constantly, until thickened, 1 to 2 minutes.
• Serve the chicken fried chicken topped with the white gravy.

Steps:

• Wash chicken legs and pat dry. In a bowl add chicken and Wishbone dressing and let sit for at least an hour (I like to marinate overnight but both work). Put peanut oil in a frying pan and warm on medium. Add flour, salt and pepper to a clean plastic bag (to shake your chicken). Shake a few pieces of chicken in plastic bag when chicken is well coated remove from bag and immediately put into hot oil. Fry for about 15 minutes turning when golden brown.

Steps:

• Preheat oven to 350 degrees F.
• Put the dressing in a wide narrow bowl so that the chicken can either be dipped (or you can marinate the chicken if you have time which will be better) and coat with the dressing.
• Put the crumbs in another bowl or shallow dish with a lip, and roll the chicken in the crumbs to coat.
• Place on a foil lined cookie sheet or Pyrex baking dish, skin side up, and bake for 1 hour or until done.