Basic Machine French Bread Recipes

Steps:

• Place 1 cup water, bread flour, sugar, salt and yeast into bread machine pan in the order recommended by manufacturer. Select Dough cycle, and press Start.
• When the cycle has completed, place dough in a greased bowl, turning to coat all sides. Cover, and let rise in a warm place for about 30 minutes, or until doubled in bulk. Dough is ready if indentation remains when touched.
• Punch down dough. On a lightly floured surface, roll into a 16x12 inch rectangle. Cut dough in half, creating two 8x12 inch rectangles. Roll up each half of dough tightly, beginning at 12 inch side, pounding out any air bubbles as you go. Roll gently back and forth to taper end. Place 3 inches apart on a greased cookie sheet. Make deep diagonal slashes across loaves every 2 inches, or make one lengthwise slash on each loaf. Cover, and let rise in a warm place for 30 to 40 minutes, or until doubled in bulk.
• Preheat oven to 375 degrees F (190 degrees C). Mix egg yolk with 1 tablespoon water; brush over tops of loaves.
• Bake for 20 to 25 minutes in the preheated oven, or until golden brown.

Steps:

• Place ingredients in bread machine according to manufacturers directions.
• Start machine on dough setting.
• When dough cycle is complete, remove dough with floured hands and cut in half on floured surface.
• Take each half of dough and roll to make a loaf about 12 inches long in the shape of French bread.
• Place on greased baking sheet and cover with a towel.
• Let rise until doubled, about 1 hour.
• Preheat oven to 450°.
• Bake for 15 to 20 minutes or until golden brown, turning pan around once halfway during baking.
• Remove baked loaves to wire racks to cool.

Steps:

• Place the water, sugar and yeast in the pan of the bread machine. Let the yeast dissolve and foam for 10 minutes. Add the oil, flour and salt to the yeast. Select Basic or White Bread setting, and press Start.

Steps:

• Add 3/4 cup water, salt, flour, parmesan cheese, garlic powder and yeast to bread machine pan in order suggested by manufacturer.
• Select dough/manual cycle.
• When cycle is complete, remove dough from machine to a lightly floured surface.
• Roll dough into a 15x10 inch rectangle.
• Beginning at long end, roll up tightly as for jelly roll.
• Pinch seams and ends to seal.
• Taper ends by gently rolling back and forth.
• Place loaf, seam side down on a greased baking sheet sprinkled with cornmeal.
• Lightly brush loaf with oil.
• Cover and let rise in warm draft-free place until almost double in size, 10 to 15 minutes.
• With a sharp knife, make 3 or 4 diagonal cuts about 1/4 inch deep across the top of loaf.
• Lightly beat egg white and 1 tablespoon water; brush some of egg white mixture over top of loaf.
• Bake at 375 for 20 minutes.
• Brush again with remaining egg white mixture and sprinkle with sesame seeds.
• Bake 5 to 10 minutes more or until done- bread should sound hollow when tapped.
• Remove the bread from the baking sheet and cool on a wire rack.

Steps:

• Add to the bread pan in the order yours needs.
• For mine it is water first.
• Then I add half the flour and the salt followed by the rest of the flour and the yeast on top.
• This will run well on the normal, rapid, and delay start cycles.