Bread Machine French Bread Recipes

Steps:

• Place ingredients in bread machine according to manufacturers directions.
• Start machine on dough setting.
• When dough cycle is complete, remove dough with floured hands and cut in half on floured surface.
• Take each half of dough and roll to make a loaf about 12 inches long in the shape of French bread.
• Place on greased baking sheet and cover with a towel.
• Let rise until doubled, about 1 hour.
• Preheat oven to 450°.
• Bake for 15 to 20 minutes or until golden brown, turning pan around once halfway during baking.
• Remove baked loaves to wire racks to cool.

Steps:

• put in machine in order and push buttons to make a 1.5 Lb french loaf.

Steps:

• Measure ingredients into baking pan in order listed.
• Black& Decker Setting 6 (Specialty- French 3H 30M cycle).

Steps:

• Add 3/4 cup water, salt, flour, parmesan cheese, garlic powder and yeast to bread machine pan in order suggested by manufacturer.
• Select dough/manual cycle.
• When cycle is complete, remove dough from machine to a lightly floured surface.
• Roll dough into a 15x10 inch rectangle.
• Beginning at long end, roll up tightly as for jelly roll.
• Pinch seams and ends to seal.
• Taper ends by gently rolling back and forth.
• Place loaf, seam side down on a greased baking sheet sprinkled with cornmeal.
• Lightly brush loaf with oil.
• Cover and let rise in warm draft-free place until almost double in size, 10 to 15 minutes.
• With a sharp knife, make 3 or 4 diagonal cuts about 1/4 inch deep across the top of loaf.
• Lightly beat egg white and 1 tablespoon water; brush some of egg white mixture over top of loaf.
• Bake at 375 for 20 minutes.
• Brush again with remaining egg white mixture and sprinkle with sesame seeds.
• Bake 5 to 10 minutes more or until done- bread should sound hollow when tapped.
• Remove the bread from the baking sheet and cool on a wire rack.

Steps:

• Add Water to your bread machine first, then add the sugar, salt, flour and yeast. Put it on your dough cycle. Check consistency of dough during cycle as you may need to add a little water or flour depending on your bread maker. When complete, roll dough out to a 12in long loaf of bread and allow to rest on a lightly floured baking sheet covered by a towel for 1 hour. With a knife cut three diagonal slashes across the top of the bread and then glaze. Bake in a preheated oven at 400F/205C for 15 to 20 minutes or until done. Allow to cool on wire tray, then enjoy.

Steps:

• In bread machine pan, place the first five ingredients in the order suggested by the manufacturer. Select dough setting (check dough after 5 minutes of mixing; add 1 to 2 tablespoons of water or flour if needed)., When cycle is completed, turn dough onto a lightly floured surface. Divide in half. Roll each portion into a 10-in. x 8-in. rectangle. Roll up jelly-roll style, starting with a long side; pinch seams to seal., Sprinkle a greased baking sheet with cornmeal; place loaves seam side down on prepared pan. Cover and let rise in a warm place until doubled, about 20 minutes., Whisk egg and water; brush over loaves. With a sharp knife, make four shallow slashes across the top of each loaf. Sprinkle with sesame seeds if desired. Bake at 375° for 20-25 minutes or until golden brown. Cool on wire racks.

Steps:

• Put the ingredients in the machine in the order listed.
• From time to time, check the dough.
• If too dry add water, if too wet add flour, always one tsp at a time.