Glazed Ginger Bars Recipes

Steps:

• Preheat oven to 350°. In a large bowl, cream butter and brown sugar until light and fluffy. Beat in molasses and egg. Combine flour, ginger, baking soda, baking powder, cinnamon and salt; add to creamed mixture and mix well. Stir in raisins. , Spread into a greased 13x9-in. baking pan. Bake 20-25 minutes or until a toothpick inserted in the center comes out clean. , Combine glaze ingredients until smooth; spread over warm bars. Cool completely on a wire rack before cutting into bars.

Steps:

• In a large bowl, combine flour, salt and baking powder. Cut in shortening until mixture resembles coarse crumbs. In a small bowl, whisk the egg yolks, lemon juice and water; gradually add to flour mixture, tossing with a fork until dough forms a ball. Divide in half. Chill for 30 minutes. , Roll out one portion of dough between two large sheets of waxed paper into a 17x12-in. rectangle. Transfer to an ungreased 15x10x1-in. baking pan. Press pastry onto bottom and up sides of pan; trim even with top edge. , In a large bowl, toss the apples, sugar, flour, cinnamon and nutmeg; spread into crust. Roll out remaining pastry to fit top of pan; place over filling. Brush edges with water or milk; pinch to seal. Cut slits in top. , Bake at 375° for 45-50 minutes or until golden brown. Cool on a wire rack. Combine glaze ingredients until smooth; drizzle over bars.

Steps:

• To make the dough, stir together the flour, cocoa powder, ginger, cloves, cinnamon, baking soda, salt, and pepper in a mixing bowl. Set aside.
• Using a stand mixer fitted with the paddle attachment, beat the butter on medium-high speed until creamy. Slowly add the granulated sugar and mix on medium speed until the mixture is completely smooth and soft. Stop the mixer and scrape down the sides of the bowl with a rubber spatula as needed.
• Add the egg and mix well. Add the molasses and corn syrup and beat until incorporated. Stop the mixer again and scrape down the sides of the bowl.
• Add the flour mixture and beat on low speed until a dough forms that pulls away from the sides of the bowl and all the ingredients are well incorporated.
• Remove the dough from the bowl, flatten it on a large piece of plastic wrap into a rectangle about 1 inch thick, cover the dough with the plastic wrap, and refrigerate overnight.
• Preheat the oven to 350 degrees. Line a baking sheet with parchment paper or a nonstick liner.
• Unwrap the dough and place on a floured work surface. If using a plaque with a design, roll out the dough 1/3 inch thick, lightly dust the top with flour, press your cookie molds over the dough, and then cut out the shapes with a small knife and place on the prepared baking sheet, spacing them about 1 inch apart. Alternatively, using the mold as a guide, cut around it with a small knife, flip the mold over so the design is facing you, and place the dough over it, pressing it into the design. Unmold the shapes onto the prepared baking sheet, leaving about 1 inch between them.
• If using a patterned rolling pin, lightly dust the lined baking sheet with flour and transfer the dough to the pan. Lightly dust the top of the dough with flour and roll it into a rectangle about 1/3 inch thick with a plain pin. Then, using the patterned pin, roll over the dough with enough pressure to ensure a clear impression of the design. Trim the sides with a small knife. It is not necessary to cut into smaller sizes before baking.
• Bake the cookies until lightly golden along the sides but still soft to the touch in the centers, 7 to 15 minutes. The timing will depending on the size of the individual cookies, or if you have made a single large patterned piece that will be cut after baking.
• While the cookies are baking, prepare the glaze. In a small bowl, whisk together the confectioners sugar and water until smooth.
• When the cookies are ready, remove from the oven and let cool on the pan on a wire rack for about 10 minutes. Then, while the cookies are still warm, using even strokes, brush a light coat of glaze on the top of each cookie, evenly covering it.
• Let the cookies cool completely. When the glaze dries, it should leave a shiny, opaque finish. If you have used a patterned pin to make a single large plaque, cut into the desired sizes with a small, very sharp knife. At the bakery, we cut them into 3-by-4-inch rectangles, but 1 1/2 by 4 inches makes a nice smaller size.