Soft Maple Sugar Candy Recipes

Steps:

• Grease a 15x10x1-in. pan with butter; set aside. In a large heavy saucepan, combine the sugar, corn syrup and water. Cook over medium-high heat until a candy thermometer reads 300° (hard-crack stage), stirring occasionally. , Remove from the heat; stir in maple flavoring. Immediately pour into prepared pan; cool. Break into pieces. Store in an airtight container.

Steps:

• Fill a large pot partially with water. Bring to a boil, and note the temperature of the boiling water with a candy thermometer. (Since water boils at different temperatures in different locations, it is important to follow this step.) Set some candy molds into a jelly-roll pan. Set aside. (If using metal or wood molds, lightly grease them.)
• Empty the large pot and place the syrup in it. Add a few drops of oil. (Boiling maple syrup will foam up; the oil keeps the foam down. Buttering the rim of the pot will also help.)
• Boil carefully over high heat, without stirring, until the temperature of the boiling syrup is 28°F/17°C above the boiling point of your water (212°F/100°C at sea level).
• Remove from the heat and let cool for 3 to 5 minutes. Do not stir or disturb the candy at this point; if the thermometer is attached to the pan, leave it there during the cooling period.
• Stir evenly until the liquid loses its gloss, starts to become opaque, and begins to thicken. (This is the tricky part; if you stir too long the thickened syrup will "set up," or harden, in the pan. If this happens, add a cup of water, and reheat slowly to dissolve the sugar, then start over. But if you don't stir long enough, the sugar may not "set up" in the molds at all.)
• Carefully pour the candy into the molds. It's helpful to have an assistant spread the syrup in the molds while you continue to pour the mixture into the other molds.
• Allow the candies to cool, remove from the molds, place on a rack to dry for a few hours, and enjoy.

Steps:

• Line an 8x8-inch baking pan with waxed paper. Butter the paper.
• Bring maple syrup, heavy cream, and brown sugar to a boil in a saucepan over medium heat. Continue to boil, without stirring, until mixture starts to bubble and registers 240 degrees F (166 degrees C) on a candy thermometer.
• Remove from heat. Add butter and salt but do not mix. Let sit until mixture reaches 105 degrees F (41 degrees C).
• Add walnuts and vanilla; beat until mixture loses its gloss. Pour into the prepared pan and let cool to room temperature. Cut, wrap, and store in the refrigerator.

Steps:

• heat maple syrup to a temperature of approximately 32-34oF above the boiling temperature of pure water (212 degrees F at sea level).
• pour the syrup into a flat pan or trough and allow it to cool undisturbed to at least 200F but not less than 160°F.
• stir until the syrup is soft and plastic.
• pour or pack it into molds. Molded candies commonly set up in 10 to 30 minutes. Candies formed by pouring rather than packing will have an attractive glazed surface.

Steps:

• Line the bottom and sides of a 9-by-5-inch loaf pan with parchment paper; brush the parchment with vegetable oil. Bring the maple syrup to a boil in a large saucepan over medium heat, then reduce the heat to medium low. Dip the back of a spoon in vegetable oil and run it over the top of the foam to help it subside. Increase the heat to medium and continue cooking until a candy thermometer registers 246 degrees F, 25 to 30 minutes. Pour the syrup into a heatproof bowl and let cool, 5 minutes.
• Beat the syrup with a mixer on medium-low speed until it starts to lighten in color and turn opaque, 30 seconds to 1 minute. Pour into the prepared pan and spread with an offset spatula; let cool completely, about 1 hour. Lift out of the pan and cut into pieces.

Steps:

• Place maple in a small saucepan and bring up to 280 degrees F. Dip a spoon into the syrup and drizzle desired shapes onto a sheet pan sprayed with vegetable oil or lined with a silpat. Let cool completely so "candies" come off the sheet pan easily. Eat as is or use as a garnish.