Easy Grilled Baby Back Ribs Recipes

Steps:

• Turn the ribs bone-side up. Slip a paring knife between the thin membrane and the bone to loosen, then pull off the membrane. Mix the brown sugar, paprika, steak seasoning, cumin and oregano in a small bowl; rub all over the ribs. Place on a baking sheet, cover with plastic wrap and refrigerate at least 6 hours or overnight.
• Preheat a grill to medium high and prepare for indirect grilling: For a gas grill, turn off one or two of the center burners and reduce the remaining burners to medium low. On a charcoal grill, bank the coals to the sides, leaving the center open; set up a drip pan to avoid flare-ups.
• Oil the grill grates. Place the ribs bone-side down, overlapping slightly if needed, on the cooler part of the grill (indirect heat). Cover and cook, rotating the rib racks once, until the meat is tender and pulls away from the bones, about 2 hours to 2 hours 15 minutes.
• Mix the honey, vinegar and a pinch each of salt and pepper in a small bowl. Transfer the ribs to direct heat. Brush with the honey mixture and continue to grill, uncovered, brushing with the honey mixture once more, until glazed, 5 to 10 minutes. Transfer to a cutting board and cut into ribs.

Steps:

• Build a fire in your grill, leaving one side free of coals. When coals are covered with gray ash and the temperature is medium (you can hold your hand 5 inches above the coals for 5 to 7 seconds), you are ready to cook. (For a gas grill, turn all burners to high, lower cover and heat for 15 minutes, then turn burners to medium.)
• Meanwhile, combine barbecue sauce with 1 cup water and stir to combine. Set aside.
• Sprinkle the ribs generously with salt and pepper, put them on the grill directly over the coals and cook for 25 to 30 minutes, turning once every 5 minutes or so, and basting with the thinned barbecue sauce, until a peek inside shows that the meat no longer has any pink at the center.
• Take the racks of ribs off the grill, cut them into individual ribs and serve.

Steps:

• Preheat a gas grill for high heat, or arrange charcoal briquettes on one side of the barbeque. Lightly oil the grate.
• In a small jar, combine cumin, chili powder, paprika, salt, and pepper. Close the lid, and shake to mix.
• Trim the membrane sheath from the back of each rack. Run a small, sharp knife between the membrane and each rib, and snip off the membrane as much as possible. Sprinkle as much of the rub onto both sides of the ribs as desired. To prevent the ribs from becoming too dark and spicy, do not thoroughly rub the spices into the ribs. Store the unused portion of the spice mix for future use.
• Place aluminum foil on lower rack to capture drippings and prevent flare-ups. Lay the ribs on the top rack of the grill (away from the coals, if you're using briquettes). Reduce gas heat to low, close lid, and leave undisturbed for 1 hour. Do not lift the lid at all.
• Brush ribs with barbecue sauce, and grill an additional 5 minutes. Serve ribs as whole rack, or cut between each rib bone and pile individually on a platter.

Steps:

• 1. In a small bowl, stir together all the ingredients except the ribs; set aside. Using a sharp knife, cut and pull the membrane from the back of each rack of ribs. Using your fingers, rub the spice mixture over ribs to coat evenly. Place each rack of ribs in a large resealable plastic bag. Refrigerate overnight, turning bag occasionally. (If ribs will not fit in a bag, place on a baking sheet and wrap well with plastic wrap.) Prepare grill for medium direct heat. Remove the ribs from the plastic bag and wrap each rack separately in a double layer of heavy-duty foil. Grill, covered, for 25 minutes. Turn packets over; grill for 25 minutes more. Test for doneness by poking a fork between the bones; the meat should be very tender. If the ribs are not done, return to the grill and cook for 10 to 15 minutes more or until fork tender. Carefully remove packets from grill. Unwrap ribs and place them directly on grill; cook for 2 to 3 minutes per side or until crisp. Transfer ribs to a cutting board. Let stand for 10 minutes before cutting into individual ribs.